Be careful not to touch your gauge needles. They are extremely delicate! Be very gentile. These faces are designed to be installed WITHOUT removing or touching the needles. Remove the screws on either side of the needle on the speedometer and the tachometer. The fuel/temp gauge does not have screws. Now, slide your gauge faces on right over your original. The center hole on your gauges is big enough to slide right over the needle starting from the tip and working inward. Once your face is in place over the original, re-install the screws. Your fuel/temp gauge has slits cut to allow you to slide it underneath the needles. Also, included in your envelope are two pieces of double sided tape. Use these to hold the fuel face in place. Put everything back together the way it was taken apart. Go slow and make sure you do it right the first time. This info was found at Four G Performance Gauges Site, they sell these gauges for DX and SI.
Information provided by: 4thgenerationcivic.com
|
White Face Gauges (indiglo)
Similar Threads
Linear Mode
