| 08-19-2005, 09:33 PM | #1 |
|
Senior Member
Join Date: Nov 2003
Location: Southern California
Posts: 2,636
 |
TOOLS REQUIRED:
= 10mm Socket/wrench = Pliers Using the pliers, remove the plastic spacing clips on each side of the seat-back pivots (1 on each side). Once these spacers are removed, you can slide the seat-backs from side to side. Push the drivers-side seat-back towards the passenger side, and the outer pivot should come loose from the hole. Do the same thing to the other side and remove both seat-backs with hatch carpeting attached. To remove the bottom seat cushion, there is one 10mm bolt to the rear of the seat (where the seat-backs used to be). Once this bolt is removed, the entire bottom cushion can be flipped up towards the front of the car. The front edge of the seat-cushion is held in place by metal tabs, and can be easily lifted out at this point. Information provided by: 4thgenerationcivic.com |
|
    
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Seatbelt Removal | oompahlumpa | 4 Gen Interior | 1 | 10-08-2008 07:09 PM |
| S2000 Seat Mod | DjHonda247 | Civic | 15 | 10-15-2004 03:31 AM |
| Rear Dash/Shelf Removal | imported_mntdewred | Civic | 13 | 12-30-2003 12:01 AM |
| ITR Seat Install | imported_mr7 | 6th Gen Interior Diys | 0 | 12-10-2003 03:24 PM |
| Rear seat removal | CeeReX | 92-95 Civic | 2 | 11-27-2003 05:02 AM |
Linear Mode
