Installing Side Markers On A Del Sol

[cynosurecivic]

This Page will give you step-by-step instructions on how to install Side Markers on your delSol

Step 1: Get all of your tools and supplies.
a. (2) side markers
b. Duck tape
c. Masking tape
d. Dermal w/ snake extension- Cutting pads
e. Wire Cutters- Extra wire
f. + shaped screw driver
g. Wire connectors - The kind that you splice a new wire into an old wire.


Step 2:
Place duck tape all around the area you are going to cut. This will help protect the paint, incase of an accident.


Step 3:
Place Masking take over the duck tape. This will give you something to write on.


Step 4:
This part is up to you! You need to find the place you want to have your side markers. I lined mine up with the center of my front turn signal.


Step 5:
Once you found the spot for your marker, take a pen and the rubber liner and trace the hole on the tape.

Step 6:
Use the dermal and start cutting.
A quick note: Always cut the hole to small. It's better to have a hole to small then one to big...!!!


Step 7:
Test fit the marker, if the hole is to small, make it bigger...If the hole is to big, well you should have read the note on "Step 6".

Step 8:
Remove the tape.

Step 9:
Add wire to the side marker, if needed.


Step 10:
Remove the mud skirt. (The rubber thing in the wheel well.)


Step 11:
Remove the front turn signals.
Step 12:
Pull the wire through the hole for the front turn signals.
Step 13:
Splice the side marker into the front turn signals.

Note:
There is two ways you can splice the wires...
Black = Ground
Green w/ yellow stripe = Flash
Red w/ Black stripe = Solid

Step 14:
Test the side marker, make sure they work. (I just turned on the Four-Way-Flashers)

Step 15:
Screw the side markers in.


Step 16:
Screw the mud skirt back on.
Step 17:
Install your front turn signals....
Step 18:
Make sure everything still works....!

Final Step: Pimp them bad boys....!!!!