| 04-25-2004, 07:02 AM | #1 |
|
Senior Member
Join Date: Jul 2003
Posts: 5,381
|
Ok easy job but some might be leary. Here' s the how to.
Tools: 1) Wratchet with extention and Plug Socket. 2) Seals and plugs. 1) Pull the wires out of the spark plug holders (if you dont have the brackets on your wires or your a moron mark which ones go where that will cause issues with misfires if you replace them wrong. 2) Pull the plugs out 3) Take off the valve cover (like the R cams baby?) 4) Pull off the old gasket and seals. 5) Now you'll know it when your holding them but there is a like a prodruding ridge on one side of the spark seal that goes on the top it will kind of lip over the metal the picture below is showing to put them on.. the lip i was talking about goes on the top show in the picture (the part that you can see of the seal) 6) Ok now get out the valve cover gasket there are little notches cut in your valve covers' gasket grove these notches match downward with the notches in the gasket 7) Put the valve cover back on and connect all youre wires. Your done. |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Spark Plugs | CivicSI2000 | Newbie Tech Questions | 8 | 11-26-2004 01:04 AM |
| What Spark Plugs Do You Use? | Doughboy | Civic | 20 | 04-14-2004 06:46 PM |
| h22 spark plug wires | imported_Vash The Stampede | General Tech | 5 | 12-11-2003 08:31 PM |
| Spark Plugs | imported_anubis155 | General Tech | 2 | 08-22-2003 01:23 AM |
| Spark Plug Wires And Plugs? | imported_fastcivicboy | Civic | 21 | 07-23-2003 12:17 AM |