help plz answer

[imported_weknowls]

ok i have a 92 cx hatch with a b-18c1 in it and for the hedders i got dc- sports 4-2-1 for the motor now exhaust wise thow would i go about doin the bolt up plz tell me how

[estebones]

you may wanna rephrase the question because I'm a bit lost...

[imported_4Bangin]

If your saying what I think your saying, your asking how to bolt up a DC 4-2-1 header to your exhaust, put on the header see if it lines up with the exhaust, if it doesnt take it to an exhaust shop and have them do it. That is as much help I can give you with the amount of info you gave me.

[simplegreen]

any civic b series that came in that chasis they had an SI with a b in it didn't they i dont think a sol will work..

basically people you need to get piping for the bent for the underside of your car.. almost all cases.. your gonna have to get the flange welded off then rewelded to match the header..

i didn't need to do this with my R motor on my 99 ex but you can tell that it's tweaked almost the extent i could have done it w/0 welding it

[imported_weknowls]

ok im talking about my hatch with a gsr motor in it has dc sport headers on it now and my tsudo cat back will be here soon do i need to buy a hi flow cat for it to work basically......just tell me how to run my exhaust from my header back to the rear plz help

[CeeReX]

Try ot bolt it up to see if it works, if not have a exhaust shop custom fit it for ya.
Damn it does not seem that hard.

[Toyz-B-Us]

You will need to shorten your exhaust about 7/8 of an inch somewhere either by shortening a test pipe or by shortening your cat back. You will also need to use an Integra cat or test pipe for the flange to bolt to the exhaust manifold properly.