What Would You Do?

[Smooth_Imports]

yeah we'll figure it out.

[simplegreen]

an update for the masses. I've alraedy talked to mike about this one. So here's the updated list of things getting done.

Things certainly getting done:

• ACT XTR Clutch
• Fidanza 7.5 Fly wheel
• 98 Integra rear disk conversion
• Walbro 255 Fuel pump
• new IAT sensor (i swear that better kill my CEL finally)
• Oil Temp gauge hooked up and installed
• Oil Pressure Hooked up and installed
• Water Temp gauge hooked up and installed
• Dual gauge bezle to replace teh stock cracked one
• n2o gauge ran, but left open for when the n2o goes in
• Wide band gauge installed
• Wide band probe installed
• ARP head studs
• Distributor 0 ring and gasket+filter replaced
• Vtec Solenoid o Ring Replaced
• Cam seal replaced (hope to get the str billet one)
• New gaskets all around, a full rebuild of the gaskets, head exhaust intake etc
• New Main bearings
• New rod bearings
• New Valve Seals
• New piston Rings
• Honed head
• New Port and polish job full intake through exhuast
• Hood pins
• Relocation of the monster tach just behind the cup holder in that storage hole

Now for the list of hope to get dones:

• C pillar Bar
• Rear Controller Arms
• Rear Tie Bar
• New Front and rear strut bars

[Smooth_Imports]

Originally posted by mdlax1@Feb 14 2005, 10:14 AM
an update for the masses. I've alraedy talked to mike about this one. So here's the updated list of things getting done.

• Rear Controller Arms
  
  
  
  
• Rear Tie Bar
  
  
  
  
• New Front and rear strut bars
  
  
  
  

these should be easy when we do the brake swap. Only a few more bolts. That rear brak swap should take no longer then a hour. the hardest part will but putting in the new Ebrake cables. (Do you even need to do that?)

[simplegreen]

yeah i have the cables, we need to do that

[Smooth_Imports]

that read disk swap is easy shit man i telling you it will be fast, Just make sure your ready to get a full alighment when were doen. toe is goign to be off crazy

[simplegreen]

yeah i get them free.. no worries

[oompahlumpa]

damn eric, you got a shit load of stuff to be done.

[simplegreen]

yeah should be good times, lot of beer and pizza thats for sure, i'll have pictures and probably vid for show

[Smooth_Imports]

Well make sure you have everything ready to go (don't be like me). Do you need me to bring anything beside the torque wrench, I'll make sure to bring both in/lbs and the ft/lbs one, Do we need my timing light, or anything else? my honda book? Just let me know. need my 32mm socket? ummmm i'm just trying to think.

[simplegreen]

yeah, bring your 32 and the timing light.. dont think we'll need the light but in case.. anyway you can get that hoist in the back of your civic lol thats it