 |
||
Tranny Problem Shifiting 2 To 3 (syncromesh?)
|
||
 |
| 03-15-2006, 10:58 PM | #1 |
|
Senior Member
Join Date: Jul 2003
Posts: 2,654
|
OK so latley i've been having problems shifting from 2/3 when i'm running the car hard. No matter how i try it (hard/fast slow/timly) it grinds, And it's not even like it grinds then then slips in, It grinds and won't go in no matter what so i'm always missing 2/3. If i drive normal everythign is 100%, I'm running a stock ls flywheel with a new (700miles) hdss act clutch. Will syncromesh help at all or is it more of a prevention product? I'm sure i've already caused to much damage for anything to work (other then replacing it)but i was just wondering. Damn i can't seem to have anyting go my way latley.
|
|
    
|
| 03-16-2006, 02:27 AM | #2 |
|
Super Moderator
Join Date: Jul 2003
Location: Nor*Cal
Posts: 2,186
 |
You could try and run it and see if it helps a little bit at least. Have you tried slowing down the 2-3 shift just a tad?
|
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Shifiting 101 | blkcivic93 | Off-Topic | 6 | 08-08-2006 04:14 PM |
| Tranny Help | civichik | General Tech | 0 | 11-26-2005 11:29 PM |
| Tranny | twowayparadise | Civic Del Sol | 6 | 02-24-2005 07:02 AM |
| Need Some Tranny Help | civic_tacoma | General Tech | 1 | 08-10-2004 10:26 AM |
| Tranny Swap Problem | imported_notyuravgjoe | General Tech | 8 | 06-07-2004 09:35 PM |
Linear Mode
