| 07-20-2003, 01:25 AM | #1 |
|
Junior Member
Join Date: Jul 2003
Posts: 6
|
I just swapped in a 97 b16b into my 97 ex. I have all of my sensors and connectors accounted for except for the crank sensor. The ex engine has a crank position sensor connection coming out of the block. The type r engine does not have this connection, what do I do? Leave it disconnected, pull the pin from the ecu, Does the type r have a crank position sensor? Please help I'm almost done!!!!!!!!
|
|
    
|
| 07-20-2003, 04:49 AM | #2 |
|
Member
Join Date: Jul 2003
Location: Sandy Ego
Posts: 68
|
The CTR does not have that sensor and the ECU doesn't look for it.
Just leave it as it were. |
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crank Pulley | Tarheelz_nc04 | Civic | 4 | 03-09-2006 02:38 PM |
| Crank Pulley | tooslow | Do-It-Yourself | 13 | 11-08-2005 05:28 PM |
| Which Crank And Rods? | Turbob20EG | Hybrid Honda | 13 | 10-25-2005 10:36 PM |
| Sometimes... My Car Wont Crank Wtf? | Doughboy | General Tech | 11 | 03-11-2005 06:06 PM |
| New Position...maybe | estebones | Off-Topic | 4 | 07-01-2004 10:36 PM |
Linear Mode
