| 04-15-2005, 10:03 AM | #1 |
|
Senior Member
Join Date: Feb 2005
Posts: 105
|
LOL.. I know, I know.. not another problem lol.. well today I installed my aem hybrid intake and all is well except I knocked off the cover on the fuel pressure regulator on the end of the fuel rail and the screw with the rubber gromet that goes in the end came out.. so I am wondering does this screw control the pressure? and I'm assuming it was in there pretty loose for it to just fall out.. should I put it back in loose or snug it up or what?
|
|
    
|
| 04-15-2005, 11:57 PM | #2 |
|
Senior Member
Join Date: Feb 2005
Posts: 105
|
Correction: Its not the fuel pressure regulator.. not sure what it is at this point.. looks kinda similiar but on the other end of the fuel rail.. has a plastic cap over it.. could it be the fuel pressure regulator?
|
|
|
|
| 04-16-2005, 12:00 AM | #3 |
|
Senior Member
Join Date: Jul 2003
Posts: 2,654
|
it;s a clear cap right? on the right of the regulator? Is so it's just a cover as long as your not leaking fuel don't worry about it./
|
|
|
|
| 04-16-2005, 10:01 AM | #4 |
|
Senior Member
Join Date: Feb 2005
Posts: 105
|
Yes thats it.. I knocked the cap off and the screw from the center fell out.. but I don't know how tight to put the screw back in.. what does this do/affect?
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aem Fuel Rail/regulator And Rc Injectors | whycrx04 | Civicland.com Classifieds | 0 | 08-12-2006 10:04 PM |
| Car Going 120 And Shut Off(not Fuel Cut) | imported_PunkRacer | General Tech | 11 | 10-10-2004 10:18 PM |
| Fuel rail install | simplegreen | General Performance DIYs | 0 | 11-16-2003 09:19 PM |
| More Fuel | imported_Vash The Stampede | Hybrid Honda | 7 | 08-14-2003 03:41 AM |
| Fuel rail install | Do-It-Yourself | 0 | 12-31-1969 11:00 PM | |
Linear Mode
