| 01-20-2004, 01:35 AM | #1 |
|
Senior Member
Join Date: Jul 2003
Location: So. El Monte, CA
Posts: 155
   |
Will any b16 crank fit into any b16. i know its sounds stupid but i just want to know. Etc.. a usdm 2000 b16 si will fit in a jdm b16 sir II ?
|
|
    
|
| 01-20-2004, 01:36 AM | #2 |
|
Senior Member
Join Date: Jul 2003
Posts: 629
|
Yes.
|
|
|
|
| 01-20-2004, 02:23 AM | #3 |
|
Senior Member
Join Date: Jul 2003
Posts: 5,381
|
i see you asking a lot of usdm b16 to jdm b16 so for future ref. 99% of all parts will fit on either
|
|
|
|
| 01-20-2004, 02:26 AM | #4 |
|
Senior Member
Join Date: Jul 2003
Location: So. El Monte, CA
Posts: 155
|
cool thanks mdlax, that answer lots of q's. i just recntly messed up my motor and need to get new stuff so i wasnt quite sure is i can us usdm on a jdm. thnaxs.
|
|
|
|
| 01-25-2004, 12:58 AM | #5 |
|
Senior Member
Join Date: Jul 2003
Location: So. El Monte, CA
Posts: 155
|
i have a similar question here.
what will happen if i put type-r piston heads in my engine, when i put the block together? Would there be any issues with the head or anything? |
|
|
|
| 01-26-2004, 06:27 PM | #6 |
|
Senior Member
Join Date: Jul 2003
Location: So. El Monte, CA
Posts: 155
|
Anyone? is this a standard replace with no other modifications?
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crankshaft Pully | karizmah | General Tech | 22 | 03-21-2005 04:54 PM |
Linear Mode
