Axles For 93 B18a In Civic

[bomegaz]

so how are things in this here forum?...dope. i'm completely new and have the limited amount of knowledge on stuff but I have a 93 B18A and it is sitting in my 91 base model civic..the one below the DX and my uncle is doing almost all the work by the way cause he is a mechanic...but not very privy to civic stuff so we have run into a couple problems. I got the axles with the engine..so 93 integra axles and the passenger axle is too big by about 2 or 3 inches. I read on another site that 88-89 integra axles are supposed to fit and somewhere else said that using 91 integra axles and an intermediate shaft works. What do I do? Also, we were wondering if the fact that it is a Canadian produced model has any bearing on the way to go about any of this. any help is fabulous.

by the way this is awesome ->

[imported_biocac]

I've got a b16 in a crx and the axle shafts had to be custom made.
You pretty much need the teg ones but you need them shortened.
I've heard of people buying both the teg and civic axles and mating the parts to create the perfact fit. It's costly, but it works great.
There were a few sets of pre-made ones on e-bay a while back that you might want to check into. I'll see what I can dig up for ya.
Hold tight.

Sam -

[bomegaz]

sweet, that may or may not work seeing how i got the hubs from the 93 integra just so the 93 axles would fit, but thanks for helping.

[bomegaz]

screw that last post im a dumbass...i got dx model civic hubs and steering knuckles. im a moron, there is no problem. that last post is void upon void

[bomegaz]

i just don't get why the passenger side axle fits fine and the driver's side one is too big. it should just fit. BAAH chicken fried rice packets of unreal