| 06-19-2005, 06:33 AM | #11 |
|
Senior Member
Join Date: Jul 2003
Posts: 2,654
|
ok so after replacing the driver side axle, i noticed that my exhuast manifold bracket (one on the rear of the block) has snapped the two 12mm bolts on the inside of the block and the bracket is layingon the half shaft. I guess thats what i get for not having anytype of flex piping in my ehaust. So the grinding is gone but now the steering wheel shakes really hard over 65mph, only if is going easy, if in hard on it over 60 all the way up to 110 it doesn't shake. only when i'm holding a steady speed over 65??
PS: I'm fucked up |
|
    
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems With Rear Axle | 17lowpros | Civic | 28 | 04-05-2006 10:53 PM |
| Help - Half Axle Trans Question | 94civ | 92-95 Civic | 8 | 12-23-2004 08:50 PM |
| Axle Nut | j diggi | General Tech | 13 | 03-25-2004 03:29 AM |
Linear Mode
