Making Msd Rev Limit Pills<6al,shift Lights,etc>

[b series us]

its real simple to do..the pill is nothing more that a resistor.and which we all know resistors have diffrent ohms or impedance...and that how the device which the pill is in knows how to cut on...now in order to make your own u need to have a multimeter and a msd pill.now say if you have a 7500 pill in your 6al,and you want 8000 measure the impedance in the 7500 pill<example 8000 = 1500 ohms>now that is not accurate so dont base your pill of this,in order to get a 8000 pill go to radio shack and buy a pack of resistors 1500ohm & up.now the resistor that you make might not be dead on but it will be close..all u have to do know is start taking the resistors and put them in your device and find the one that suit your needs.to make it more easy you can take two msd pill one higher one lower that what you need check the ohm betwwen the two, now its easier to figure what ohm you need because you know what ohm not to exceed..

i thought i would share this with you all..i bet i lot of you are saying i just go but some and forget about the hassle,well thats not me i like to be creative&and ilike to share knowlage wih others...so if i think of somthing else yall will the first to know

[NstyGrnHatch]

you can do this to your IAT sensor to fool the ECU to think the engine is drawing in colder air than it really is to dump a little more fuel into the engine. Its an easy 2-3hp.

[b series us]

yeah i did that to me and my buddies car..it made a diff on the stock ecu.it pulled all the way to red line,but when he put a chipped ecu in we took them out and ran the car down the track it ran the same time it did with them in there..