| 05-28-2005, 03:26 AM | #1 |
|
Junior Member
Join Date: May 2005
Posts: 3
|
So i bought one of these MSD SCI-L but i would like to know if there any tricks to installing it on a 91 crx with a zc. also. i have a zdyne conversion ecu. it kinda acts like it is over fueling at idle. it drops to like 550 rpms at times. I have checked the temps on the exhuast. the 4th cylinder is running about 50-80 F colder then the rest. and my number one cylinder is running about 20-30 F colder. it was worse when i was running an integra computer. it would bog alot more on take off. what are the common fixes for this. Also i have bought a two step modual to hook up to use as a launch rpm controller. where would i wire into the clutch or should a use a button some where to control that? thanks in advance. Andy Roberson, Columbia Tn
|
|
    
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help With Installation | Mexcivico | 92-95 Civic | 6 | 09-07-2006 05:49 PM |
| Installation Help! | Mexcivico | 92-95 Civic | 1 | 09-06-2006 04:13 AM |
| Help On Installation Of Crunch Amp And 2 6x9.. | killertofu | Newbie Tech Questions | 6 | 08-06-2004 07:09 AM |
| Camber Kit Installation | roxysurf | Newbie Tech Questions | 13 | 07-03-2004 05:01 AM |
| Oil Cooler Installation | Smooth_Imports | General Performance DIYs | 0 | 05-13-2004 02:51 PM |
Linear Mode
